Brodit Holder med genom-gångskontakt TomTom XXL
Aktiv hållare för fast installation. Me... (518039)
Skaffetid (få varen raskere mot et tillegg)
5+ på lager hos leverandør
Sendes fra oss 3-5 dager*
Fleksibel betaling med AfterPay
kr 10.000 over 12 mnd. = 977,- / mnd.
Effektiv rente 35,39%, Totalt kr 11.722,-
The choice for you want to have charging to your GPS device, as well aswant to have it neatly and securely mounted in the car. With your GPS in an active holder, you will always have a freshly charged battery and your GPS within easy sight and reach! The holder is equipped with a straight cable with open end for fixed installation. The cable is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior.
The holder is also equipped with a pass-through connector, so all miniUSB-cables that can be used with the GPS device can also be used with the holder (e.g. a charging or TMC cable). This means you can have both charging and TMC connected to the GPS in the same time! When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the device each time you put the GPS in the holder.
The holder is placed on the dashboard, providing you with an unobstructed view. You can easily take your GPS with you when leaving the car. 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto a ProClip Mounting Platform.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot!
Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the Black wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. 3. All cables that fit the device can be attached to the holder. 4. The holder is in place.
Brodit Holder with Pass-Through Connector. DC voltage range: 12/24 V
Andre kunder kjøpte også